|
Product Details:
|
| Material Options: | Dense MDF, Moisture-resistant MDF, Pine | Length Options: | 2400 / 2700 / 4880 Mm |
|---|---|---|---|
| Pattern: | Egg-and-dart, Bead And Reel, Plain Ogee | Surface: | Primed White, Raw, Painted To RAL |
| Installation: | Adhesive Plus End Pins | Application: | Dining Rooms, Hallways, Wainscot Caps, Stairwells |
| Custom Service: | Matched Baseboard And Crown Versions, OEM Lengths | ||
| Highlight: | egg-and-dart chair rail,primed decorative wood trim,easy install chair rail |
||
The egg-and-dart band is the classical profile most often used at chair rail height, because the alternating ovoid and arrow shapes throw a shadow line that reads clearly at eye level without becoming busy. This rail carries the pattern at 40mm centres along a 70mm high face, so the repetition stays even across a full room rather than drifting at hand-cut joints.
The body is dense MDF with a primed face and a rebated back edge, so the rail sits flat against drywall and covers the transition between a painted upper wall and a panelled lower section. At 18mm thick the profile stands far enough off the wall to cast a shadow, but not so far that chair backs knock against it in a dining room.
Key Features| Parameter | Specification |
|---|---|
| Material | Dense MDF, moisture-resistant option |
| Length | 2400 mm (2700 / 4880 mm optional) |
| Height | 70 mm |
| Thickness | 18 mm |
| Pattern Repeat | 40 mm centres, egg-and-dart |
| Surface Finish | Primed white, sanded |
| Dimensional Tolerance | ±0.3 mm |
| Packing | 12 lengths per bundle, shrink wrapped |
Chair rail is installed at roughly 900mm above floor level to protect walls from chair backs and to divide a wall into two visual fields. In dining rooms, hallways and stairwells the egg-and-dart band gives the division a classical reference, and the same profile is often repeated at baseboard height for a matched scheme.
Because the back is rebated, the rail also works as a cap for tongue-and-groove panelling, wainscot panels and board-and-batten layouts. Installers normally set out from the room corners, cutting a 45 degree return at each end, so the pattern meets cleanly at the terminal point.
Packaging & Quality AssuranceTwelve lengths are bundled and shrink wrapped with end caps, then stacked flat on pallets with corner protection. Bundles carry profile code, length and batch number for traceability.
Checks cover pattern repeat, rebate depth and primer coverage in the recesses. Any length showing a filled motif or a lifted primer edge is rejected before packing.
Contact Person: johnliu